Howdy,
Im running a 2.6.10 kernel from kernel.org, which has been compiled to use the hdtv3k as a DVB card. It also has support for the air2pc card as well. I just got mine air2pc card today and Im not sure where I should put the dvb-fe-nxt2002.fw. I thought it was /lib/firmware; I didnt have that dir so I made it, and copied the *.fw to that dir, as well as to /etc/hotplug, but I cant get the card to tune any channels. Then dmesg says the following when I run azap
nxt2002: Waiting for firmware upload (dvb-fe-nxt2002.fw)... nxt2002: Waiting for firmware upload(2)... nxt2002: no firmware upload (timeout or file not found?) nxt2002: timeout error writing tuner
and so on. I see that in my modprobe.conf when kudzu detected the card it put in an alias eth1 skystar2, should that be there? Shouldnt it be some other alias than eth1? Could that be my problem? In the rest of dmesg, I can see that the card is found and is initialized
ACPI: PCI interrupt 0000:01:08.0[A] -> GSI 10 (level, low) -> IRQ 10 drivers/media/dvb/b2c2/skystar2.c: FlexCopIIB(rev.195) chip found drivers/media/dvb/b2c2/skystar2.c: the chip has 38 hardware filters DVB: registering new adapter (SkyStar2). saa7115: starting probe for adapter SkyStar2 (0x10000) flexcop_i2c_func DVB: registering frontend 0 (Nextwave nxt2002 VSB/QAM frontend)... nxt2002: Waiting for firmware upload (dvb-fe-nxt2002.fw)... nxt2002: Waiting for firmware upload(2)... nxt2002: no firmware upload (timeout or file not found?)
The same channels can be picked up by the pchdtv3k, so Im sure the air2pc should be able to get them with the same antenna. Anyone have any ideas as to where I place the firmware so that it can be uploaded?
Tom
_______________________________________________ mythtv-users mailing list mythtv-users@mythtv.org http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
