RE: [mythtv-users] Installation problem

Dave Sun, 17 Apr 2005 00:42:25 -0700

Title: Signature

Is there something else besides the qt3.3.4 bug that will prevent the mythtvsetup menu from appearing?

I just did a fresh install of Mythtv using Jarods guide. I ran into the could not get past the “clear card setting issue” . and downgraded to qt 3.3.3.8 (off of the FC3 CD’s) using rpm –Uvh –oldpackage (4 qt packages).

Now I am able to get past the clear card/channel settings however the menu system never comes up to configure mythtv.

mythtvsetup –v shows nothing unexpected.

-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Cyber Source
Sent: Saturday, April 16, 2005 2:46 PM
To: Colin Smillie; Discussion about mythtv
Subject: Re: [mythtv-users] Installation problem

Colin,
Thank you very much, ctrl-enter did the trick and I do have that version of qt. That one would have drove me nuts!!! Thanks again!
p.s. Any experience with a PVR-350? I used AverTV cards before with alot of luck, can't seem to get this PVR-350 workin. TIA

Colin Smillie wrote:

On 4/16/05, Cyber Source <[EMAIL PROTECTED]> wrote:

Hello All,

  I've installed Mythtv many times without troubles, now I can't seem to

get 0.17 installed.  It behaves very strangely, running mythtvsetup gets

me to the startup screens but then it will not move between screens,

only the esc key seems to work and I can't get the install started. I

This sounds like the qt 3.3.4 bug, check the list archives or try

ctrl-enter on the setup screens.

Thanks,

Colin

_______________________________________________

mythtv-users mailing list

[email protected]

http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users

--

                         115 Richfield Road
               Williamsville, New York 14221
                            716-553-8525

<<image001.jpg>>

_______________________________________________
mythtv-users mailing list
[email protected]
http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users

RE: [mythtv-users] Installation problem

Reply via email to