On 6/21/05, Phill Edwards <[EMAIL PROTECTED]> wrote: > > I have been battling this thing for about a 3 weeks now.. I cannot for > > the life of me figure out what happened. Everything was working > > smoothly with .17 with SPDIF playing out through my SiS 735 SI7012 > > (intel8x0) on board sound card. Then after I did an apt-get upgrade I > > get no sound whatsoever. I can't even do a /usr/bin/aplay > > /usr/share/sounds/KDE_Startup.wav as suggested by Jarod's guide. > > > > aplay -l shows the following: > > card 0: SI7012 [SiS SI7012], device 0: Intel ICH [SiS SI7012] > > Subdevices: 1/1 > > Subdevice #0: subdevice #0 > > > > I can't tell you what the alsa-mixer settings were since I have been > > playing with them trying to figure which is correct. I definately > > have IEC958 slider set to zero. > > > > My /home/mythtv/.asoundrc looks identical to this one off of Jarod's site. > > http://wilsonet.com/mythtv/asoundrc.txt > > > > My modprobe.conf for audio looks like the following: > > # sound card setup > > alias snd-card-0 snd-intel8x0 > > install snd-intel8x0 /sbin/modprobe --ignore-install snd-intel8x0 && > > /usr/sbin/alsactl restore >/dev/null 2>&1 || : > > remove snd-intel8x0 { /usr/sbin/alsactl store >/dev/null 2>&1 || : ; > > }; /sbin/modprobe -r --ignore-remove snd-intel8x0 > > Don't know much about SPDIF, but my guess would be that your sound > card settings have got trashed in the upgrade. You need to use > alsamixer to get the settings right as per Jarod's guide. If you have > a BT8x8 card then you usually have to configure the line-in so that it > records the sound. Or maybe your sound-out/PCM settings are on mute. I > have an intel on-board sound card with screenshots of the settings > which I'll send you separately. Remember that I don't have SPDIF, > though. > > Regards, > Phill >
Hmm.. I have newer version of alsamixer v1.0.9. I am looking athe IEC958 setting and I do not have PCM like yours shows. It only says 00. Also, when I go to the mixer through the KDE menu and pull up the GUI version IEC958 is not set.. and if I set it and the try to play something through mplayer and then go back into the GUI the IEC958 setting is unchecked again. _______________________________________________ mythtv-users mailing list [email protected] http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
