Thanks Steve, great directions. I just hadn't applied the DVB patches. It's getting closer to working now. :-)
Jul 25 07:57:45 goose kernel: b2c2-flexcop: B2C2 FlexcopII/II(b)/III digital TV receiver chip loaded successfully Jul 25 07:57:45 goose kernel: flexcop-pci: will use the HW PID filter. Jul 25 07:57:45 goose kernel: flexcop-pci: card revision 2 Jul 25 07:57:45 goose kernel: ACPI: PCI Interrupt Link [LNK4] enabled at IRQ 3 Jul 25 07:57:45 goose kernel: ACPI: PCI Interrupt 0000:01:09.0[A] -> Link [LNK4] -> GSI 3 (level, low) -> IRQ 3 Jul 25 07:57:45 goose kernel: DVB: registering new adapter (FlexCop Digital TV device). Jul 25 07:57:45 goose kernel: b2c2-flexcop: MAC address = 00:d0:d7:30:19:69 Jul 25 07:57:45 goose kernel: b2c2-flexcop: i2c master_xfer failed Jul 25 07:57:45 goose last message repeated 2 times Jul 25 07:57:45 goose kernel: i2c_readbytes: i2c read error (addr 0a, err == -121) Jul 25 07:57:45 goose kernel: bcm3510: Revision: 0x1, Layer: 0xb. Jul 25 07:57:45 goose kernel: b2c2-flexcop: found the bcm3510 at i2c address: 0x0f Jul 25 07:57:45 goose kernel: DVB: registering frontend 0 (Broadcom BCM3510 VSB/QAM frontend)... Jul 25 07:57:45 goose kernel: b2c2-flexcop: initialization of 'Air2PC/AirStar 2 ATSC 1st generation' at the 'PCI' bus controlled by a 'FlexCopIIb' complete Jul 25 07:57:45 goose kernel: ACPI: PCI Interrupt Link [LNK3] enabled at IRQ 11 Jul 25 07:57:45 goose kernel: ACPI: PCI Interrupt 0000:01:08.0[A] -> Link [LNK3] -> GSI 11 (level, low) -> IRQ 11 [EMAIL PROTECTED] ~]# /usr/local/bin/azap KCBS using '/dev/dvb/adapter0/frontend0' and '/dev/dvb/adapter0/demux0' tuning to 749000000 Hz video pid 0x0000, audio pid 0x0000 status 00 | signal 0000 | snr 0000 | ber 00000000 | unc 00000000 | status 00 | signal 0000 | snr 0000 | ber 00000000 | unc 00000000 | _______________________________________________ mythtv-users mailing list [email protected] http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
