|
I am trying to determine if I have a faulty board or I just
have a setting that does not work. I am following wilsonet for FC4 instruction. This
works great for me as I have the identical hardware/software (FC4 and two
captures cards PVR250 and a PVR500) I recently installed the PVR500 following wilsonet and also
found on the mythtv user mail list the instruction on updating the firmware for
the PVR500. When I did this I had both tuners on the card working well
using the cat /dev/video1
> /tmp/test_capture.mpg suggested by willson. Unfortunately
in my haste to get the card working I screwed up something in my mythsetup that
caused my hard drive to be filled and I was only able to access the system in
fail safe mode. I corrected this problem by deleting the MySQL database. Just to make sure everything was working correctly I
reinstalled the firmware for the PVR500 and ran the cat /dev/video1 > /tmp/test_capture.mpg test again This time
only one of the tuners (video2) worked, video1 just gives a gray screen. I have checked
and re-checked. All my setting re follows the recommendation of
wilsonet. Normally I would assume that I have a setting wrong, but being
I have seen these settings work before by backend crash I am beginning to
suspect a hardware problem. Does any one
have any suggestions? Chris |
_______________________________________________ mythtv-users mailing list [email protected] http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
