Thanks, Joshua, I'll give that a try. I had quite a few messages with
Hans Verkuil on the ivtv-users list about this. He didn't mention any
similar problems. I think I will try rolling back the driver though.
I'll post my results.
Kirk
Joshua Frank wrote:
I had the same problem. I eventually just reinstalled ivtv 0.4.0. But if
you want to play with some thing interesting try this command
ivtvctl -d /dev/video0 -q 1
This tells your ivtv card to use audio channel 1 instead of 0. I heard
that the was a problem with the drivers no selecting the correct
channel. Could be worth a try.
On 12/31/05, *Kirk Bocek* <[EMAIL PROTECTED] <mailto:[EMAIL PROTECTED]>> wrote:
I upgraded my MythTV system from ivtv 0.4.0 and kernel 2.6.13.2
<http://2.6.13.2> to ivtv
0.4.1 and kernel 2.6.14.4 <http://2.6.14.4> and now I get no sound
on my PVR-350 from
either live tv or recorded programs.
Sound system is working - Xine playing DVDs and MythMusic output
sound fine.
I've reset the settings in alsamixer/amixer: master and PCM to 75%
unmuted, CD (which the PVR-350 is plugged into) at 75%, muted and
set as
the capture source. Internal cabling has not changed from my previously
working ivtv 0.4.0 setup.
The correct msp3400 is being loaded -- I compiled ivtv from source and
executed the recommended mv commands.
Any suggestions?
My init messages are below.
Thanks,
Kirk
ivtv: ==================== START INIT IVTV ====================
ivtv: version 0.4.1 (tagged release) loading
ivtv: Linux version: 2.6.14.4-wcpvr01 SMP gcc-3.4
ivtv: In case of problems please include the debug info between
ivtv: the START INIT IVTV and END INIT IVTV lines, along with
ivtv: any module options, when mailing the ivtv-users mailinglist.
ivtv0: Autodetected WinTV PVR 350 card (cx23415 based)
ACPI: PCI Interrupt 0000:01:02.0[A] -> GSI 17 (level, low) -> IRQ 185
ivtv0: Unreasonably low latency timer, setting to 64 (was 32)
ivtv0: i2c attach to card #0 ok [client=tveeprom, addr=50]
tveeprom 0-0050: The eeprom says no radio is present, but the tuner type
tveeprom 0-0050: indicates otherwise. I will assume that radio is
present.
tveeprom 0-0050: Hauppauge model 48132, rev K268, serial# 2985761
tveeprom 0-0050: tuner model is LG TAPE H001F MK3 (idx 68, type 47)
tveeprom 0-0050: TV standards NTSC(M) (eeprom 0x08)
tveeprom 0-0050: audio processor is MSP4448 (idx 27)
tveeprom 0-0050: decoder processor is SAA7115 (idx 19)
tveeprom 0-0050: has radio, has IR remote
tuner (ivtv): chip found at addr 0xc2 i2c-bus ivtv i2c driver #0
ivtv0: i2c attach to card #0 ok [client=(tuner unset), addr=61]
saa7115 0-0021: ivtv driver
saa7115 0-0021: saa7115 found @ 0x42 (ivtv i2c driver #0)
ivtv0: i2c attach to card #0 ok [client=saa7115, addr=21]
saa7127 0-0044: ivtv driver
saa7127 0-0044: saa7129 found @ 0x88 (ivtv i2c driver #0)
ivtv0: i2c attach to card #0 ok [client=saa7127, addr=44]
msp3400 0-0040: ivtv driver
msp3400 0-0040: chip=MSP4448G-A2 +nicam +simple +simpler +radio
mode=simpler
msp3400 0-0040: msp34xxg daemon started
ivtv0: i2c attach to card #0 ok [client=MSP4448G-A2, addr=40]
tda9887 0-0043: (ivtv) chip found @ 0x86 (ivtv i2c driver #0)
ivtv0: i2c attach to card #0 ok [client=tda9887, addr=43]
ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes)
ivtv0: loaded v4l-cx2341x-dec.fw firmware (262144 bytes)
ivtv0: Encoder revision: 0x02050032
ivtv0: Decoder revision: 0x02020023
ivtv0: Allocate DMA encoder MPEG stream: 256 x 32768 buffers (8192KB
total)
ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB
total)
ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB
total)
ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB
total)
ivtv0: Create encoder radio stream
ivtv0: Allocate DMA decoder MPEG stream: 16 x 65536 buffers (1024KB
total)
ivtv0: Allocate DMA decoder VBI stream: 512 x 2048 buffers (1024KB
total)
ivtv0: Create decoder VOUT stream
ivtv0: Allocate DMA decoder YUV stream: 48 x 43200 buffers (2048KB
total)
ivtv0: loaded v4l-cx2341x-init-mpeg.bin firmware (155648 bytes)
tuner: type set to 47 (LG NTSC (TAPE series)) by ivtv i2c driver #0
tuner: switching to v4l2
tuner: tv freq set to 67.25
tuner: tv 0x07 0x10 0x8e 0x01
ivtv0: Initialized WinTV PVR 350, card #0
ivtv: ==================== END INIT IVTV ====================
_______________________________________________
mythtv-users mailing list
[email protected] <mailto:[email protected]>
http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
<http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users>
--
Joshua Frank
[EMAIL PROTECTED] <mailto:[EMAIL PROTECTED]>
------------------------------------------------------------------------
_______________________________________________
mythtv-users mailing list
[email protected]
http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
_______________________________________________
mythtv-users mailing list
[email protected]
http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
