Hi Gary, Thanks for the update, OK that's all good and shows that for the right port value the correct Drive Select LED lights up. I'd just like to confirm you are using the MYIDE V2.9 Diagnostic ? (I use the 4K ROM based version which only accesses one drive - no copy operation in the menu) Can you do the following for me:- Place one of your CF cards in the *right hand CF slot P41* and *remove* the left hand adapter. In your MYIDE software select Drive A (menu item 'A' i think) Verify that D18 lights up (Select Drive A) Now use menu items 'I' and 'R' to verify that you can step through sectors and read data from the CF card to the buffer/display on screen. If all is well then swap the adapter to the left hand slot P40 Select Drive B (menu item 'B') Verify that D19 lights up (Select drive B) again use menu items 'I' and 'R' to verify that you can step though sectors and read data to the buffer/display on screen. The purpose of this is to test both slots independently and check the corresponding slot does in fact match what the LED's indicate. If your CF cards are blank it might be useful to put some data onto them with a hex editor (HxD) in the first few sectors. Regards David Fry
On Tuesday, March 18, 2014 10:27:41 PM UTC, Edward Snider wrote: > Hi everybody, > > I'd like to do a board distribution project of Dual CF-Card/Hard Disk IDE > S-100 > Boards<http://s100computers.com/My%20System%20Pages/IDE%20Board/My%20IDE%20Card.htm> > . > > Is anyone interested in getting one or more of these? > > Just post here and I'll get a list started. > > Thanks, > > Ed > > -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
