Hello David, I had hoped you would see this post, and I thank you for the reply. I used the version of MYIDEROM and all the files right out of your zip.
Regards, Thomas On Wednesday, June 11, 2014 4:27:30 PM UTC-4, David Fry wrote: > > Hi Thomas, > > If I understand you correctly you are using the ROM version of MYIDE to > boot the system, > Did you use the version inside the zip archive I uploaded to my folder or > are you using a version downloaded off of the S100 computers website ? > > regards > > David Fry > > On Wednesday, June 11, 2014 8:35:13 PM UTC+1, Thomas Owen wrote: > >> Now that I have my IDE card passing all the preliminary tests, I am >> trying to install CP/M on the Compact Flash drive and get the system to >> boot. >> >> >> >> *System:* >> >> Compupro ZPU at 2 mhz. >> >> IDE CF Card, version 2.0a >> >> IMSAI SIO for console >> >> Ram 17 with Eprom installed at ‘E000’ >> >> 8 gb Kingston CF >> >> >> >> Have read, and re-read all the articles I can on the site, and decided to >> use the method put together by David Fry found here. >> >> >> >> >> http://s100computers.com/My%20System%20Pages/IDE%20Board/Z80%20CP_M%203.0%20build.pdf >> >> >> >> Step 1 - I modified HLDRBIOS.ASM to support my Console device (IMSAI SIO) >> >> >> >> Step 2 - I modified CHARIO3.ASM to support my Console device >> >> >> >> Step 3 - Assembled and built the CPMLDR.COM >> >> >> >> Step 4 - Copied it to the CF at Sector 0 >> >> >> >> Step 5 - Assembled and built the CPM3.SYS and copied it to the CF at >> sector 112 >> >> >> >> Step 6 - Moved sector 48 to sector 63 on the CF >> >> >> >> I know the install is not complete, but at this point I wanted to see >> what a ‘Boot’ looked like from David’s MYIDEROM: >> >> >> *At boot I see displayed on the console and MYIDEROM reports this drive >> information:* >> >> >> >> Cyl: 3C82 Heads: 010 >> Sectors: 0048 >> >> >> >> Then I choose ‘C’ for Boot CP/M and here is where I see a problem: >> >> >> <https://lh3.googleusercontent.com/-ibKBwi-w_f4/U5iuJ6yv_5I/AAAAAAAABZY/7cqFbc7Wl8M/s1600/cpmboot.jpg> >> >> >> >> >> Notice the ‘LBA = 003C003C’. Why is that value so high and incorrect? >> >> >> >> Any suggestions to getting is completed? >> >> >> >> Thanks in advance, >> >> >> >> Thomas >> >> -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
