John -
At least for me, your images boot just fine without a functional ZFDC
board in the system. It boots with the ZFDC board and no floppy drives,
or no ZFDC board.
I'm using a SMB, Serial I/O, Propeller Console I/O, Parallel board, Z80
CPU and 4mb SRAM.
I am using the earlier V4.57 of your monitor (for some reason I can't
get the V5.02 to work properly, open to ideas!).
- Gary
On 6/21/2014 12:49 AM, John Monahan wrote:
Dave not sure why your system is hanging without the ZFDC board. In the two systems I
have here, one has the ZFDC board the other does not. I flip the CF cards around all
the time. If the ZFDC board is not present I put out a warning "Failed to initialize
the ZFDC Board" but then the loader continues on. If I pull the ZFDC board out on
my main system, also no hang! Wish I could be of more help -- I'm so bogged down on
other boards right now I can't get my head above water. I have one more week to do a
lot then on a 3 week vacation (Grease, Turkey -- forget internet!). Want to try and get
a few things completed before I go.
John
-----Original Message-----
From: [email protected] [mailto:[email protected]] On
Behalf Of yoda
Sent: Friday, June 20, 2014 8:38 PM
To: [email protected]
Subject: RE: [N8VEM-S100:4311] Another route to write a CPM3 image to a CF card
for the S100 IDE board
Yes but before you put the image on the CF card you can add/delete files with
the cpmtools because they know the underlying CPM file system of the image.
That is the beauty of this implementation. I would not put the floppies in the
base images until you fix it so the system does not hang if the board is not
detected.
Dave
--
You received this message because you are subscribed to the Google Groups
"N8VEM-S100" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
For more options, visit https://groups.google.com/d/optout.
