Sorry frank I’m a bit confused as to what you are doing. The ZFDC.HEX file is in the .zip file. Can you not burn it into a PROM from the HEX file
The SLR Z80 Assembler is supplied here:- http://s100computers.com/Software%20Folder/Assembler%20Collection/Assembler%20Collection.htm I assume by now you know how to use the SIMH Altair Simulator to run the assembler on your PC. If not see here:- http://s100computers.com/Software%20Index%20Page.htm John From: [email protected] [mailto:[email protected]] On Behalf Of Frank Schieschke Sent: Friday, August 1, 2014 1:26 AM To: [email protected] Subject: [N8VEM-S100:4768] Re: ZFDC Controller under control of the PC-BIOS?? Yesterday i build the Prop I/O board to exchange my CompuPro Interfacer1 board. The Prop I/O works at once, but the problem with the ZFDC controller is the same. I used the newest firmware for the ZFDC controller i get from the website. But i have no possibility at the moment to compile a defined new one. I use the TASM cross assembler for the 8080 and Z80 code. To use TASM with the given source code, there are a lot of syntax changes to do. I am going the next days to fit the source for TASM. Frank -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
