Hello folks, I just completed the SMB V2 and apart from a couple of bad soldiers and faulty flat cables, I had no major problems, thanks to Franck's instructions as I also had to make the mod on U10. I plan to make some changes vs the original setup, the mezzanine will only be used for the TIL311 displays, I will put the switched and LED's on a separate board. Also, I will use a push button for Reset, Save Clear and Single Step. On this one, I had to swap wires as my push button has the common pin on 1 (not in the center - pin 2 - as this is the case for a usual switch). Below a picture of the front panel I just drilled mounted on the modushop case, now I still have to figure out how to get a nice looking printout - I would like to do it myself and not rely of FPE at first ... My plan is to solder the LEDs and switches to a board I will mount on the front panel, and then insert a printed sheet between the panel and a plexiglas panel. Could be interesting to share experiences there, as I am sure some experts over there have already managed to get cool looking panels on their system.
cheers Philippe <https://lh5.googleusercontent.com/-ED05MzMbo9E/U-e-OyIeu0I/AAAAAAAAAHM/p6Vz8VE6yN4/s1600/photo%2B1.JPG> <https://lh3.googleusercontent.com/-EnQWXCXKVNQ/U-e-YW2K0lI/AAAAAAAAAHU/GI0YHF6q_S0/s1600/photo%2B2.JPG> -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
