The 03 is the currently selected drive I seem to remember, but check John
From: [email protected] [mailto:[email protected]] On Behalf Of Gary Kaufman Sent: Friday, August 15, 2014 7:28 PM To: [email protected] Subject: Re: [N8VEM-S100:4947] Re: ZFDC Controller under control of the PC-BIOS?? Success!!! I haven't had time for any extensive testing, but was able to boot to a prompt. What a great feeling :) One curiosity is that the V2.9 ZFDC.HEX file cleared the display to "00000" and then began rolling the first two digits. This later V3.5 ZFDC.HEX leaves a "3" in the far right digit. I'll have to look thru the code, but is this an error message? John (and Frank), thanks so much. - Gary On 8/15/2014 3:59 PM, John Monahan wrote: That’s great news Frank! Gary, how about you? John From: [email protected] [mailto:[email protected]] On Behalf Of Frank Schieschke Sent: Friday, August 15, 2014 12:39 PM To: [email protected] Subject: [N8VEM-S100:4937] Re: ZFDC Controller under control of the PC-BIOS?? Hello John, Thanks for the version 3.5 that you published on your site. I just burn the EEPROM. And now i am able to boot MS-DOS (in my case 3.3) from the floppy disk. Frank -- -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
