Ian you could try using a small red panel plastic window in front of them all. In fact that is what I did for my SMB with the front panel. The red light shines through, nothing else John
-----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Ian McLaughlin Sent: Monday, September 29, 2014 1:16 PM To: [email protected] Subject: [N8VEM-S100:5278] TIL311 displays for S100-IDE board Hello all, I'm in the millde of building the S100-IDE board to drop in to my NorthStar Horizon. The final pieces showed up today, but there's a bit of a problem, and wondering if anyone else has seen this? I acquired 10 TIL311 displays from an eBay seller but when they arrived, they have an obvious gouge on the display surface that has been filled in with a black marker. All 10 of them. To me it looks like factory seconds that were marked with a gouge. Here's a picture: https://www.dropbox.com/s/j8lmciw8n9kys13/IMG_3182.jpg?dl=0 Has anyone else seen these displays like this? I've filed a dispute with the seller because they are nothing like the condition of the picture in the auction. I'll give them a go, but esthetically they're terrible. Any suggestions on an inexpensive source for these displays in non-gouged-and-filled-in state? Thanks. Ian -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
