I would be interested Jim
Sent via the Samsung Galaxy S™ III, an AT&T 4G LTE smartphone -------- Original message -------- From: Don Caprio <[email protected]> Date: 12/07/2014 11:40 PM (GMT-05:00) To: [email protected] Subject: Re: [N8VEM-S100:5777] NKK Switches for Mini FP Folks are starting to get the switches for the FP mini board and asking about a switch bracket. The switch bracket has two important purposes. One is for the positioning of the switches when you solder them in. I've tried doing this without a bracket and it's very difficult to get them lined up perfect without some sort of jig. I already have a quote from sheet metal fabricator here in town to produce one. In small quantities it was $15 USD. I'm thinking that I can do these on my mill, probably five or six at a time for just the cost of materials. I already have drill bits and tap for the tiny screws. I'm going to give it a try this week. If your interested in a bracket please let me know so I can gage the interest level. We may be to produce a few and pass them onto other builders on a 'loaner' basis. However my original plan was to use the bracket for installation and as a strain relief in the chassis. Please feel free to send along your ideas and suggestions. Thank you. On 12/ 7/14 03:17 PM, G. Beat wrote: > Before I setup the bench for assemblying this board, later this month, > Did someone develop a switch frame (or std. Process) for maintainibg > alignment, as I solder these switches? > -- Don Caprio [email protected] -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
