It's on the N8VEM Wiki. Near the bottom of the Front page
there is a section for S-100 boards. Board 16 is the front panel.
http://n8vem-sbc.pbworks.com/w/browse/#view=ViewFolder¶m=S-100%20FPMini
On 12/14/14 11:32 PM, Paul Birkel wrote:
Just color me dumb, Don. Where is the FP Mini Wiki that you mention?
On Thu, Dec 11, 2014 at 4:20 AM, Don Caprio <[email protected]
<mailto:[email protected]>> wrote:
*Attention FP Mini builders *
...
If you've been watching the Wiki, I do regret that the RUN and HALT
LED's got swapped. You have two choices here. Change the silkscreen,
or wait for a fix. I attempted some jump and cut and borked my
board. Luckly I was able to restore and got it operational again.
I do have
a fix that does not require cuts and jumpers. It's a bit cheesy so I'm
reluctant to share at this point. Basicaly involves placing tape
over the
component holes and using the long LED leads to reach the proper
holes.
I am planning on a V2 board. It will have the LED fix, all jumpers
moved
to a dip switch on top of the board and line drivers for the S100
bus signals
which should allow the board to run better at higher speeds. It's
going to be
tricky finding real estate for the extra components, but I'm up
for the
challenge.
Thank you all for supporting this project.
...
--
Don Caprio
[email protected] <mailto:[email protected]>
--
You received this message because you are subscribed to the Google
Groups "N8VEM-S100" group.
To unsubscribe from this group and stop receiving emails from it,
send an email to [email protected]
<mailto:[email protected]>.
For more options, visit https://groups.google.com/d/optout.
--
You received this message because you are subscribed to the Google
Groups "N8VEM-S100" group.
To unsubscribe from this group and stop receiving emails from it, send
an email to [email protected]
<mailto:[email protected]>.
For more options, visit https://groups.google.com/d/optout.
--
Don Caprio
[email protected]
--
You received this message because you are subscribed to the Google Groups
"N8VEM-S100" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
For more options, visit https://groups.google.com/d/optout.
