Thanks Don. Dumber, me. Hadn't connected that page with "Wiki" in my mind. Who reads GUIs anyway ...
On Mon, Dec 15, 2014 at 10:57 AM, Don Caprio <[email protected]> wrote: > > It's on the N8VEM Wiki. Near the bottom of the Front page > there is a section for S-100 boards. Board 16 is the front panel. > > http://n8vem-sbc.pbworks.com/w/browse/#view=ViewFolder¶m=S-100%20FPMini > > > > On 12/14/14 11:32 PM, Paul Birkel wrote: > > Just color me dumb, Don. Where is the FP Mini Wiki that you mention? > > On Thu, Dec 11, 2014 at 4:20 AM, Don Caprio <[email protected]> wrote: >> >> >> *Attention FP Mini builders * >> >> ... >> >> If you've been watching the Wiki, I do regret that the RUN and HALT >> LED's got swapped. You have two choices here. Change the silkscreen, >> or wait for a fix. I attempted some jump and cut and borked my >> board. Luckly I was able to restore and got it operational again. I do >> have >> a fix that does not require cuts and jumpers. It's a bit cheesy so I'm >> reluctant to share at this point. Basicaly involves placing tape over the >> component holes and using the long LED leads to reach the proper holes. >> >> I am planning on a V2 board. It will have the LED fix, all jumpers moved >> to a dip switch on top of the board and line drivers for the S100 bus >> signals >> which should allow the board to run better at higher speeds. It's going >> to be >> tricky finding real estate for the extra components, but I'm up for the >> challenge. >> >> Thank you all for supporting this project. >> >> ... >> >> -- >> Don [email protected] >> >> -- >> You received this message because you are subscribed to the Google Groups >> "N8VEM-S100" group. >> To unsubscribe from this group and stop receiving emails from it, send an >> email to [email protected]. >> For more options, visit https://groups.google.com/d/optout. >> > -- > You received this message because you are subscribed to the Google Groups > "N8VEM-S100" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/d/optout. > > > -- > Don [email protected] > > -- > You received this message because you are subscribed to the Google Groups > "N8VEM-S100" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/d/optout. > -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
