I just tried, using v1.2 I can run Zork 1-3 on com port, no prop I/O, it's not supported. Remember: on my system when using the com port, I can only see the first file when I do a 'dir'. I know the files are there because I can see them using v2.3 & the prop I/O.
----- Original Message ----- From: "Jeff Albrecht" <[email protected]> To: [email protected] Sent: Friday, February 27, 2015 4:09:40 PM GMT -06:00 US/Canada Central Subject: Zork load under v2.3 was - Re: [N8VEM-S100:6467] Re: CP/M running, But now what ? I happened to be experimenting with a disk image made from the v1.2 ROM/Bios today on my system running a v2.3 ROM/Bios. It was behaving oddly. I remember reading about Zork loading oddly in a thread so I tried Zork and it behaved as described above. Powered down changed jumpers, put the original v1.2 ROM in the board with the SD card as delivered. I ran zork in this configuration fine. Then I re-installed the v2.3 ROM and carefully made a new boot disk from the "FIRMWARE and CPM V-Disk Images AIR-V23.zip" file. Zork did not run. Also LS hung the system consistently as did some other files on A:. Stat ran fine consistently. Are other folks running v2.3 ROM and bios ok? Perhaps check their A:LS and c:zork3 - jeffa -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected] . For more options, visit https://groups.google.com/d/optout . -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
