Any of those values are fine Jeff for these low ampage applications. If you are going to be doing and serious S100 board construction etc., you should stock up on basic components getting them in the 10’s or 100’s. IC sockets, 0.1uF caps, 1K, 4.7K, 470 resistors and 6 & 10 pin arrays to name just a few.
They are not expensive and much cheaper in bulk John From: [email protected] [mailto:[email protected]] On Behalf Of Jeff Albrecht Sent: Friday, May 29, 2015 8:54 AM To: [email protected] Subject: Re: [N8VEM-S100:7118] S100 extender board Question about the capacitors for the 7805 on the S-100 extender board. Might I substitute a couple 1uF Electrolytic capacitors for C1 and C3 as I have them available on-hand to me in my shop. I see the values 0.33uF and 0.1uF called for on the extender board schematic, just as a typical circuit in the 7805 datasheet indicates. I see such a wide variety of values in schematics out in the DIY world. Must they be polarized? I've got some 50v ceramics on-hand of those values. -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
