Mr. Caryl Whitlatch wrote, On 18-01-2007 22:49: > RO given, but failed to contact IP device by SNMP (IP devices of > this category are required to answer). > > > My NAV box has a 10.7.x.x addy behind an Astaro Linux firewall and that is > doing the NAT translation. I have used Zenoss in this same network setup > and not had a problem with SNMP but I found it too hard to configure so am > trying NAV. I even tried opening up all ports so no traffic coming back > would be blocked. > > > I see the SNMP traffic leave my NAV box and go across through the firewall. > > > I can telnet from my NAV box to the router. I can do a snmpwalk to that > router from the NAV box so I know it can see it and get SNMP traffic back > through the firewall.
But were you able to add other devices? Did you attempt to add these two devices again? If you are in fact able to reach them using snmpwalk from the NAV box, then maybe EditDB timed out waiting for a response? You also say you see the SNMP traffic leave your NAV box and go across through the firewall, but do you see the response packets come back the other way? Then again, you also say you experienced the integer serial number error when attempting to add each device through the regular add form, which says to me that NAV actually did get a response from the device... Mysterious, for sure... -- mvh Morten Brekkevold UNINETT _______________________________________________ nav-users mailing list [email protected] http://mailman.itea.ntnu.no/mailman/listinfo/nav-users
