Hi Jens,

Is it a big relay? Could be that the PIC is trying to energize the relay, through
input protection diodes in the 4049, when in battery mode.

R11 is across 5V input. RA2 is connected to +5V input. Is that a schematic mistake?

Do you really need the relay. Why not just use D1 and D2. Diode current is zero because 5V input voltage is slightly higher etc. The relay is not an improvement.

Connect VCC IC2 and IC8 to IC1. Use software to turn off leds, when in battery mode. Or make one led flash shortly every 2 seconds, to preserve power in backup mode.

Cheers, Frank



----- Original Message ----- From: "jb-electronics" <[email protected]>
To: <[email protected]>
Sent: Friday, April 01, 2011 9:42 AM
Subject: [neonixie-l] OT: Help with birthday present needed


Hi again,

OK, this should be a new thread. As indicated earlier, the schematic in http://www.jb-electronics.de/tmp/clock_schematic.png produces some unpredictable PIC behavior (i.e. the little guy heats up sometimes with no apparent reason while in battery mode).

Could a reason be the CD4094 registers and the TLC549 ADC that are disconnected via the diodes while in battery mode? There could be some current flowing from one IO to another PIC IO through the unsupplied CMOS CD4094 registers or the TLC549 ADC that would work as a diode in that case.

Now the question would be: how much current do CD4094 and TLC549 draw in quiescent mode? The CD4094 goes down to about 5uA, so that is not too bad, but I have no clue about the TLC.

Any ideas?

Best regards,
thanks for your time,
Jens

--
You received this message because you are subscribed to the Google Groups "neonixie-l" group.
To post to this group, send an email to [email protected].
To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/neonixie-l?hl=en-GB.


--
You received this message because you are subscribed to the Google Groups 
"neonixie-l" group.
To post to this group, send an email to [email protected].
To unsubscribe from this group, send email to 
[email protected].
For more options, visit this group at 
http://groups.google.com/group/neonixie-l?hl=en-GB.

Reply via email to