Hi all,

many thanks again for the great advice I received on- and offlist.

I have managed to complete the clock in time for my sister's birthday, and it works like a charm. I used RA5 (the MCLR pin) as the voltage check pin (this is the controller's HV compatible pin) and I removed the ADC and replaced it by a simple switch. The clock now draws less than 1uA in standby, this should last.

Many thanks again,
Jens


Am 01.04.2011 17:18, schrieb GastonP:
Jens, if the outputs of the PIC are not floated then every "1" you put
to the 4094s inputs will be shorted by a diode to ground (the
protective input diode, which by virtue of the Vcc being = ground in
battery mode is being turned on). In the sleep mode everything is
floated, but be careful in which state the pins are the brief moment
you take it out of that state.

On Apr 1, 7:48 am, jb-electronics<[email protected]>  wrote:
Hello Frank,

Is it not possible to connect the wiper from R13 potentiometer
directly to RA0?
And connect it to the comparator? Yes, that would work, but I have no
timer left.

If you want to keep it, you can also power the TLC549 from RB3, OE.
That is not possible I guess, since the OE is PWMed, you know, and I
don't know how the ADC likes it if he is at .5V average ;-)

I think I will remove the ADC for now, since it would have had to be
adjusted by a screwdriver anyway. I will just add another switch and
adjust the brightness this way.

My sister's birthday is tomorrow and I would like to get finished in the
next hours since I have to travel 2 hours by train to get home, you
never know how long it takes using the "Deutsche Bahn". ;-)

Best regards,
Jens









----- Original Message ----- From: "jb-electronics"
<[email protected]>
To:<[email protected]>
Sent: Friday, April 01, 2011 12:24 PM
Subject: Re: [neonixie-l] OT: Help with birthday present needed
So I guess I will have the TLC549 at the main supply, as it draws
tooo much current in idle mode, it is 0.7mA. So I think the only way
is to connect the TLC549 before the diodes at JP1.

--
You received this message because you are subscribed to the Google Groups 
"neonixie-l" group.
To post to this group, send an email to [email protected].
To unsubscribe from this group, send email to 
[email protected].
For more options, visit this group at 
http://groups.google.com/group/neonixie-l?hl=en-GB.

Reply via email to