Hopefully this is a very simple question. ;) The datasheet for my IN-14's say the powersupply voltage is 190V. Looking at the guide below from "the skydrive" shows that the voltage as measured between Vsup and GND is 190V as I expect. But it also shows the voltage (Vn) as applied to the tube from GND to the nearest side of the anode resistor is only approx 140V. And the voltage across the anode resistor (Vr) is about 50V. See here:
https://skydrive.live.com/?cid=f9db37b8211ce831&sc=documents&id=F9DB37B8211CE831%21119#cid=F9DB37B8211CE831&id=F9DB37B8211CE831%211376&sc=documents So.... When I am adjusting my HVPS for my tubes, do I adjust it so that there is 190V as measured from GND to the actual tube anode, or 190V as measured from GND to the pre-tube side of the anode resistor? The datasheet shows the tube running at 190V. But the sky drive shows only 140V at the tube and calls it typical (?!?!?!?) Is the objective to adjust the anode R and pot on the HVPS to balance 190V as measured at the actual tube with 2.0ma of current? Or are you doing it so 2.0ma hits the GND/anode resistor at 190V? Confused, -Ryan -- You received this message because you are subscribed to the Google Groups "neonixie-l" group. To post to this group, send an email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/neonixie-l?hl=en-GB.
