Ah, I expected you to use both primaries still.
To do that the primaries have to be kept in the same phase.
Thus the wire of Primary 2 that was common with Primary 1 has to be moved to
the opposite end of Primary 1. The other end of Primary 2 now has to be
moved to where the original common point was at the end of Primary 1.
eg S= start of winding, E = end of winding, 1 = pri one, 2 = pri two..
originally 230V :-
S1111111111ES2222222222E
intended 115V :-
S11111111111E
S22222222222E
John K.
[power reasons as in Charles' post]
----- Original Message -----
From: "Konstantin" <[email protected]>
To: <[email protected]>
Sent: Sunday, August 26, 2012 3:28 AM
Subject: RE: [neonixie-l] Re: Elektronika 7-06M
Hi John,
I thought that instead of 2 serial connected winds, for 110V supply to use
only 1 wind, so there is no cross phase problem there. Or am I missing
something?
Best regards, Konstantin
www.kosbo.com
-----Original Message-----
From: [email protected] [mailto:[email protected]] On
Behalf Of JohnK
Sent: Saturday, August 25, 2012 2:29 PM
To: [email protected]
Subject: Re: [neonixie-l] Re: Elektronika 7-06M
Careful, I thought that you would need to reconnect BOTH wires because of
phase.
John K.
----- Original Message -----
From: "Konstantin" <[email protected]>
To: <[email protected]>
Sent: Saturday, August 25, 2012 10:23 PM
Subject: RE: [neonixie-l] Re: Elektronika 7-06M
...clip...
Clock transformer has 2 winds rated for 110volts connected in series, so
I
believe,
it's quite simple to re-solder one wire for one wind use for
110-120Vmains,
as in USA.
--
You received this message because you are subscribed to the Google Groups
"neonixie-l" group.
To post to this group, send an email to [email protected].
To unsubscribe from this group, send email to
[email protected].
For more options, visit https://groups.google.com/groups/opt_out.
