Hello I just build my own Nixie clock with input from Arduinix.com and a power supply from ledsale (Build a nixie power supply - LEDsales<http://www.google.ch/url?sa=t&rct=j&q=nixie%20power%20supply&source=web&cd=5&cad=rja&ved=0CEEQFjAE&url=http%3A%2F%2Fwww.ledsales.com.au%2Fkits%2Fnixie_supply.pdf&ei=-smQUbLsKvD24QSX9IDgDA&usg=AFQjCNEiqKM6Acf_mlaSDuBrhUqL2A5Uvw&sig2=Bi2PdGfH0ERKhqQkk5wFQA&bvm=bv.46340616,d.bGE> )
Attached find the circuit and the pcb from fritzing. The clock works fine but when I adjust the high voltage with R36 the ds1307 module from Twig http://shop.boxtec.ch/twig-ds1307-p-40355.html starts to flicker because on the serial interface it shows strange numbers like *165*:*165*:85. After a while it does not return the time over the i2c interface at all. A restart of the nixie clock starts showing the time again. With an oscilloscope I can see that after a certain position on R36 the SDA puls disapear and it shows a flat line. I think it is at high level. Not so shure how to read the oscilloscope. Any Idea why? I don't see a direct link from the high voltage power supply to the 2 wire interface. (see attached circuit) Kind regards Sergio -- You received this message because you are subscribed to the Google Groups "neonixie-l" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send an email to [email protected]. To view this discussion on the web, visit https://groups.google.com/d/msg/neonixie-l/-/jgtKRhvfY7IJ. For more options, visit https://groups.google.com/groups/opt_out.
