On 9/7/14 9:53 AM, jb-electronics wrote:
Hi folks,
I want to adjust the output voltage of the Taylor Edge HVPS 1363 [1]
digitally via a microcontroller. I drive the HVPS with 12V to have
maximum output current.
I know that I could just select the voltage with a couple of switches
and resistors, but is there a way to do that digitally?
Thanks for your input,
Jens
[1] http://tayloredge.com/storefront/SmartNixie/PSU/index.html
Jens,
You can use an analog multiplexer chip to switch in different resistors
using logic signals. The ADG series form Analog Devices is good, if a
bit expensive. There are other lower-cost options if you want to design
a bit of circuitry.
--
David Forbes, Tucson AZ
--
You received this message because you are subscribed to the Google Groups
"neonixie-l" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
To post to this group, send an email to [email protected].
To view this discussion on the web, visit
https://groups.google.com/d/msgid/neonixie-l/540C900C.9060200%40dakotacom.net.
For more options, visit https://groups.google.com/d/optout.
