Thanks Martin.  I knew something was very different about these tubes.  I 
had bought one a long time ago and when I hooked it up to 170V it seemed 
like the tube was bad at the time which was upsetting.  Luckily I kept it!  
It wasn't until I learned more about them that I realized I wasn't handling 
them correctly.  The datasheet I'm looking at suggests DC 250V with 10k on 
the anode plus 8.2k on the 1 cathode and 4.7k on the 7 cathode.

Best Regards,

Bill
On Tuesday, August 25, 2020 at 4:43:14 AM UTC-7 Dekatron42 wrote:

> These need a higher Anode voltage (minimum 220V in some datasheets and 
> 250V in some) to work properly and also cathode resistors on cathodes "1" 
> and "7" to get correct current as the digits are not size corrected to get 
> equal current compared to the other cathodes - you will destroy the 
> cathodes faster otherwise.
>
> They are somewhat sensitive to shaking as the welds sometines come loose 
> due to the heavy ceramic piece affecting the welds on the underside if it 
> is shaken violently.
>
> I used discrete transistors, MPSA42 and CMOS CD4028 plus some resistors.
>
> /Martin
>
>
>

-- 
You received this message because you are subscribed to the Google Groups 
"neonixie-l" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
To view this discussion on the web, visit 
https://groups.google.com/d/msgid/neonixie-l/b6564561-0f71-451b-8c16-33f6af668b84n%40googlegroups.com.

Reply via email to