Ty the unused inputs to ground with a 10K resistor, float the unused outputs.
Bill -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of chuckrr Sent: Thursday, April 01, 2021 8:53 AM To: [email protected] Subject: [neonixie-l] LM-324 op amp What is standard procedure for tying off unused op-amp inputs? If for instance there is a circuit which uses only (2) of the (4) available op-amps in a DIP package, what is the normal protocol for dealing with these unused units? Can the unused inputs just be left floating? Doing do on an LM-324 runs the output at around 7.45 volts when the chip is operating from a single 9 volt supply. Does doing this draw more current than tying off inputs to GND? Thanks, Chuck -- You received this message because you are subscribed to the Google Groups "neonixie-l" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web, visit https://groups.google.com/d/msgid/neonixie-l/202104010552851.SM619381%40ADT-IM1. -- You received this message because you are subscribed to the Google Groups "neonixie-l" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web, visit https://groups.google.com/d/msgid/neonixie-l/00f601d726fc%242cfc5f30%2486f51d90%24%40gmail.com.
