> On Jun 10, 2021, at 9:56 PM, gregebert <[email protected]> wrote: > > Would it be possible to 3D-print the rear section of the pushbutton, then > glue the engraved cover onto it ?
The two "prongs" are wide and very thin. Like shim brass, which may be a starting point. OTOH, there may be electrical contact inside the switch. I'd take some pictures but I don't have one that's intact and I don't know what to search for. Terry Bowman, KA4HJH "The Mac Doctor" https://www.astarcloseup.com “...the book said something astonishing, a very big thought. The stars, it said, were suns but very far away. The Sun was a star but close up.”—Carl Sagan, "The Backbone Of Night", Cosmos, 1980 -- You received this message because you are subscribed to the Google Groups "neonixie-l" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web, visit https://groups.google.com/d/msgid/neonixie-l/0DB439B1-1744-4304-8AC3-6957C231823F%40gmail.com.
