gotchya. on my desk i just have to punch down another couple feeds from the panel on the back. so (not that i don't believe you!) this doesn't adversely affect the output stage of the master? i'd think changing the effective input imp. the 2-mix output is seeing would result in funk-ay-ness.
-pete On Feb 20, 2012, at 1:45 PM, Kyle Mann wrote: > Correct. However, my console was configured with 1/4" i/o on the back, so > it's simply a Y split — one going to the amp, one to the sub. > > On Monday, February 20, 2012, pete wrote: > hey kyle... > > ok so this sounds like the exact same setup i'm envisioning... i.e. running > the dyns full range and filling in the bottom with the sub. so when you say > "passive split" off the mon. A outs... are you literally wiring the sub right > off the same terminals that the hafler is fed with? > > thanks bro. > > p > > On Feb 20, 2012, at 1:39 PM, Kyle Mann wrote: > >> Pete, >> >> I'm using a Velodyne VA-1215X in conjunction with my ProAc Studios (powered >> by a Hafler 9505). The Velodyne does have a speaker-thru, but since I wanted >> to run the monitors full-range and use the sub to fill in the 20-50Hz area, >> I'm simply using a passive split off the Monitor A outs of my Series 1E. No >> problems whatsoever. >> >> Kyle >> >> On Monday, February 20, 2012, pete wrote: >> quick question for the list... >> >> i have a cheap-o active sub i'd like to integrate into my series IIIc here >> (just to get a basic idea of subsonic junk going on in mixes) and am >> wondering the best and or easiest way to go forward. >> adding the sub in parallel with say the speaker A outs (on which there is a >> set of active Dynaudio bm6a) effectively lowering the input imp. seen by the >> master module i take it is not the way to go.... >> my initial thought is to take a line out of the 2-mix #3 in the patchbay and >> send that to the sub... i really wanted to be able to switch it out though >> when i am on the smaller avantone monitors on speaker select A. >> >> any tips from people using subs on their older neotek setups? >> >> thanks!! >> >> pete------ >> >> View the list online at: http://www.mail-archive.com/[email protected] >> >> You can unsubscribe at anytime by sending an email to >> mailto:[email protected] with "unsubscribe neotek" in the message >> body. If you have any difficulties, or questions --please send an email to >> mailto:[email protected]. >> >> The Neotek list is lovingly hosted by Catapult Web. Remember that any >> message or reply sent to the list will be automatically forwarded to all >> subscribers. >> >> Vive Le Neotek! >> >> Thanks. >
