Hi,
I installed net-snmp-5.1.1
./configure
make
make install
When I used "mib2c -c mib2c.access_functions.conf xxx" to generate template
code, it showed "perl module not installed".
So I change to the net-enmp/perl directory and execute following commands:
perl Makefile.PL
make
make install
But I still got the same error!
I also tried to install using following commands:
./configure --with-mib-modules
make
make install
Unfortunately, it still didn't work!
Is there any one know this issue?
永鈦鑫 iTAS Corporation
新竹科學園區工業東三路6號
NO. 6, Industry E. Rd. III, Science Park, Hsin-Chu, Taiwan 300, R.O.C.
Tel:03-6662595 Ext.1208
E-mail:[EMAIL PROTECTED]
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Net-snmp-coders mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/net-snmp-coders
