umnn, i don't have the equipment to get the video of the screen. i can provide reports using other operating systems, do let me know.
> From [email protected] Mon May 7 16:08:41 > 2018 > From: Hisashi T Fujinaka <[email protected]> > X-X-Sender: [email protected] > To: Kathe <[email protected]> > cc: [email protected], [email protected] > Subject: Re: 8.0 rc1 barfs during install > Sender: [email protected] > > My guess is that you're going to have to get a video of the screen > during installation. > > On Mon, 7 May 2018, Kathe wrote: > > >> From [email protected] Mon May 7 > >> 15:50:58 2018 > >> From: Martin Husemann <[email protected]> > >> To: Kathe <[email protected]> > >> Cc: [email protected] > >> Subject: Re: 8.0 rc1 barfs during install > >> Sender: [email protected] > >> > >> On Mon, May 07, 2018 at 03:46:33PM +0000, Kathe wrote: > >>> i have an amd64 system which runs well with freebsd, openbsd and ubuntu. > >>> with netbsd 8.0 rc1, it barfs while outputing the message below; > >>> sdhc0: adma error, status ff > >>> sdhc0: timeout waiting for mask 0x3 value 0 (state=0xffffffff) > >>> sdhc0: command or data phase inhibited > >>> sdhc0: timeout waiting for mask 0x3 value 0 (state=0xffffffff) > >>> sdhc0: command or data phase inhibited > >> > >> Could you provide any details? > >> Does it hang at that point, just wait for a bit and then continue to boot? > >> If possible send the full output of the dmesg command, please. > >> > >> Martin > >> > > > > my system works well with freebsd, openbsd, ubuntu. > > under netbsd 8.0 rc1, the following message keeps getting printed; > > sdhc0: adma error, status ff > > sdhc0: timeout waiting for mask 0x3 value 0 (state=0xffffffff) > > sdhc0: command or data phase inhibited > > sdhc0: timeout waiting for mask 0x1 value 0 (state=0xffffffff) > > sdhc0: command or data phase inhibited > > sdhc0: timeout waiting for mask 0x1 value 0 (state=0xffffffff) > > sdhc0: command or data phase inhibited > > sdhc0: timeout waiting for mask 0x3 value 0 (state=0xffffffff) > > sdhc0: command or data phase inhibited > > sdmmc0: sdmmc_mem_enable failed with error 60 > > sdmmc0: couldn't enable card: 60 > > > > i can't get to the point of plucking out the dmesg, the message > > above keeps getting repeated till the point i power-down the > > system. > > > > -- > Hisashi T Fujinaka - [email protected] > BSEE + BSChem + BAEnglish + MSCS + $2.50 = coffee >
