Hello Isaac,
>
> > Question 3. When using Genesis I know you can up the baud rate etc as
> > I spoke to Chris about this, but what are the best settings to put the
> > standard serial prefs at.
>
> 020 (!) - 38400
> 030 - 57600
> 040 - 57600/115200
> 060 - 115200
>
> The higher the setting, the more CPU time is needed to service the serial port.
> If you do it more than these recommended numbers, the serial port can't cope
> and ends up very slow. Also, make sure you're using artser.device, and not
> serial.device.
>
Where do you get artser.device?, I had a look on aminet but I can't
seem to find it anywhere.
Cheers,
donny
_____________________________________________________________
NetConnect mailing list. To unsubscribe, send an 'unsubcribe'
message to <[EMAIL PROTECTED]>
