Tom Chen wrote:
> Hello,
>
> I have a strange issue. After my GLDV3 driver is stalled, the default NIC (on
> the motheboard) driver e1000g does not get IP address but I can see "e1000g0
> link up, 1000 Mbps, full duplex" from the /var/adm/messages. I tried to fix
> by using "Network Settings" menu but it hangs up.
>
I'm confused. Is this a new GLDv3 driver you wrote?
Are all your entry points non-blocking? If you have a thread that gets
stalled in your driver, then it can hork the entire networking stack, I
think.
You must not block or stall in GLDv3 entry points.
-- Garrett
> I am wondering what is wrong?
>
> Tom
>
>
> This message posted from opensolaris.org
> _______________________________________________
> networking-discuss mailing list
> [email protected]
>
_______________________________________________
networking-discuss mailing list
[email protected]
