Hi Mads, Is it a 10/100 Mbps or 10/100/1000 Mbps PHY used on your system? Please give the output of "dladm show-dev" with nfo driver.
With nge driver, please disable the 1000 full-duplex capability with "ndd -get /dev/nge0 adv_1000fdx_cap 0" to see whether the link can be up. Thanks, Lucy Mads Toftum wrote: > On Fri, Dec 28, 2007 at 10:43:15AM +0800, Xiu-Yan Wang wrote: > >>MCP51 Ethernet Controller have already be supported by nge boundled both >>in Solaris 10 and SXDE. As Garrett suggested please make sure that an IP >>address is assigned to the interface. >> > > I've got problems with MCP51 as well: > > pci bus 0x0000 cardnum 0x14 function 0x00: vendor 0x10de device 0x0269 > nVidia Corporation MCP51 Ethernet Controller > CardVendor 0x1043 card 0x816a (ASUSTeK Computer Inc., Card unknown) > STATUS 0x00b0 COMMAND 0x0007 > CLASS 0x06 0x80 0x00 REVISION 0xa3 > BIST 0x00 HEADER 0x00 LATENCY 0x00 CACHE 0x00 > BASE0 0xfe02c000 addr 0xfe02c000 MEM > BASE1 0x0000dc01 addr 0x0000dc00 I/O > MAX_LAT 0x14 MIN_GNT 0x01 INT_PIN 0x01 INT_LINE 0x0b > BYTE_0 0x43 BYTE_1 0x10 BYTE_2 0x6a BYTE_3 0x81 > > Nge will detect it just fine, but as soon as the driver loads, link goes away. > I can even pxe boot from it, but I've only had it functional with the nfo > driver and of course it also works on other os'es. I've tested on sxce 68 - > 77. > > vh > > Mads Toftum _______________________________________________ networking-discuss mailing list [email protected]
