Hi -
I've recently installed Mandrake 5.3, and all went well.� However, on my
system, the modem, com3 (ttyS2) uses IRQ 11, not the normal default one.� On
Caldera, there was an rc.serial initialization script that was run during
boot.� Since it's not in the mandrake installation, where is the recommended
place to setserial to change where the system expects the interrupt for the
com port?
�
Thanks,
Bill
�
< http://www.TroikaNetworks.com <http://www.troikanetworks.com/> >
"The greatest obstacle to understanding is
�not ignorance, but the illusion of knowledge!"
�
