Hi Dan,
I will give that a try. I am not sure what you meant by "where 2=<x=<254". I
think maybe a typo in there.
The reason for two ethernet cards is because the Cisco 675 is an external
router and it hooks up to a NIC with a crossover cable. So the first one is
for the router and the second is for my small home LAN.
Thank you again. I am off to try that.
Rich
> -----Original Message-----
> From: [EMAIL PROTECTED]
> [mailto:[EMAIL PROTECTED]]On Behalf Of Dan Brown
> Sent: Saturday, June 26, 1999 5:45 PM
> To: [EMAIL PROTECTED]
> Subject: Re: [newbie] DSL and Mandrake
>
>
> From: Rich McCabe <[EMAIL PROTECTED]>
>
> > The eth0 card is configured as 192.168.1.1 with a netmask of
> 255.255.255.0
>
> OK, it sounds like your router is configured to be on a different
> network. Assuming that your eth0 card is the one that's connected to
> the router, set its IP to 10.0.0.x, where 2=<x=<254. Do likewise with
> all other machines on the network. Alternatively, you might try
> enabling dhcp on the linux box (and the other machines).
>
> > default gateway____________
> > default gateway device__________
>
> 10.0.0.1 for both, I believe.
>
> > And then if I click add I get
> >
> > Device_________________
> > Network_______________
> > Netmask_______________
> > Gateway_______________
>
> You wouldn't need to add another network interface, AFAIK.
>
> > I have tried to ping the router at 10.0.0.1 and 2 and cant get a
> response.
>
> The router is at .1; 10.0.0.2 seems to be your Win box. My guess is
> that your Linux box doesn't know how to route to 10.0.0.1, which is why
> it doesn't get a response.
>
> I'm not sure, though, why you have two NICs in the Linux box. With
> this setup (using a separate router), you shouldn't need a second one.
>
>
>
