On Saturday 02 Nov 2002 7:01 am, Derek Jennings wrote: > Well if it is not able to install all the SANE RPMs then of course it will > not capture images. You may have a bad update source defined. > Take a look at the sources in Mandrake > ControlCentre>Software>SoftwareSources Try replacing your update source > with this one . > ftp://ftp.rediris.es/pub/linux/distributions/mandrake/updates/9.0/RPMS > > You might also like to install the libsane, sane-backends, xsane and > xsane-gimp RPMS from the software manager instead of letting scannerdrake > do it.
I have umax astra 2000P. I installed using control center/hardware. Still I can't use my scanner. I get error no device found with xsane. What to do? in /etc/sane.d/dll.conf # enable the next line if you want to allow access through the network: #net umax_pp I edited line in umax_pp.conf file also for port. Initially it was port /dev/usb/scanner0 Since it is a parallel port scanner attached to lp1, I used as follows port 0x378 Even after restarting linux, xsane couldn't find scan device. What to do? -- L.V.Gandhi 203, Soundaryalahari Apartments, Lawsons Bay colony, Visakhapatnam, 530017 MECON, 5th Floor, RTC Complex, Visakhapatnam AP 530020 INDIA
Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com
