El S�b 02 Nov 2002 12:55, L.V.Gandhi escribi�:
> On Saturday 02 Nov 2002 7:01 am, Derek Jennings wrote:
> > Well if it is not able to install all the SANE RPMs then of course it
> > will not capture images. You may have a bad update source defined.
> > Take a look at the sources in Mandrake
> > ControlCentre>Software>SoftwareSources Try replacing your update source
> > with this one .
> > ftp://ftp.rediris.es/pub/linux/distributions/mandrake/updates/9.0/RPMS
> >
> > You might also like to install the libsane, sane-backends, xsane and
> > xsane-gimp RPMS from the software manager instead of letting scannerdrake
> > do it.
>
> I have umax astra 2000P. I installed using control center/hardware. Still I
> can't use my scanner. I get error no device found with xsane. What to do?
> in /etc/sane.d/dll.conf
> # enable the next line if you want to allow access through the network:
> #net
> umax_pp
> I edited line in umax_pp.conf file also for port. Initially it was
> port /dev/usb/scanner0
> Since it is a parallel port scanner attached to lp1, I used as follows
> port 0x378
> Even after restarting linux, xsane couldn't find scan device. What to do?
Hola, Gandhi.
MDK xsane, and all related stuff (for UMAX Astra, and compatibles) are
broken. Justo go to http://umax1220p.sourceforge.net/ and follow
instructions. Works fine here.
Suerte.
--
Pilag�
GNU/Linux Mandrake 9.0
9:44pm up 53 min, 2 users, load average: 0.36, 0.16, 0.05
Want to buy your Pack or Services from MandrakeSoft?
Go to http://www.mandrakestore.com
