Dennis Myers wrote:
On Saturday 09 November 2002 10:26 am, John Richard Smith wrote:Yes, that's the key to it,first find and install from cd1 :-
Dennis Myers wrote:John check and see if you have liblm_sensors1-2.6.4-4mdk installed, it looks like what you d/l'd may be different versions and they aren't compatible. My system has lm_sensors-2.6.4-4mdk installed and the above liblm and works dandy. HTH
On Saturday 09 November 2002 09:25 am, John Richard Smith wrote:Well I did that but yet again I get
Tom Brinkman wrote:John if you go to rpmfind.net and type the libpng12.so.0 in the find box,
On Friday November 8 2002 07:46 pm, Roger Sherman wrote:Tom,
On Wed, 6 Nov 2002, Tom Brinkman wrote:First, not all motherboards support hardware monitoring. If you see
If it's from lm_sensors, it'sI know this has been covered here before, but I can't find it in the
comin from a probe (thermistor) that either reads one of the cpu's
pins, or is in contact with the die. From a pin is slightly
better,
archives (I can never find anything in those damn archives!). How
does one set up lm_sensors, once installed?
temps, voltages, etc. in bios the board does. If you don't it most
likely doesn't. If it does, then run (as root) 'sensors-detect'
You'll go thru a list of questions, in most all cases just hit <Enter>,
eg, take the default answer to all of 'em. The script will then
generate a few lines and tell you which to put in /etc/modules.conf
or at the very end of rc.local. Back in sensors-detect there's one more
question, write a config file? Say yes, and you're done. Then run
rc.local, eg, '/etc/rc.d/rc.local'. Then typing 'sensors' as root or
user should display your voltages, fan speeds and temps.
I downloaded lm_sensors-2.6.4-4mdk.i586.rpm,
It wanted CD2 , I gave it, but still it reported ,
libpng12.so.0<>=s is needed by lm_sensors-2.6.4-4mdk.i586.rpm,
with no clue as to where to find it.
Do you think it's worth chasing this dependency or is it not much
hope.
John
it will give you the actual rpm that that file is in. You can download
the file or see if it is on you CDs and install. HTH
libpng3 <>=s1.2.1-6mdk is needed by libpng3-devel-1.2.1-6mdk
I checked the install discs previously and all libpng rpm's listed are
installed
except for something on CD1 /mnt/cdrom/Mandrake/mdkinst/lib/libpng.so.3
which is not an rpm file and seems to be something to aid the mandrake
installer.
This is turning into a chase my tail job. I think I will leave it.
John
liblm_sensors1-2.6.2-4mdk.i586.rpm
liblm_sensors1-devel-2.6.2-4mdk.rpm
then cd2:-
liblm_sensors1-static-devel-2.6.2-4mdk.1586.rpm
lm_sensors-2.6.2-4mdk.i586.rpm
all goes on sweetly, now to configure it.
John
--
John Richard Smith
[EMAIL PROTECTED]
Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com
