On Saturday 07 Jun 2003 2:18 pm, Marco Verheul wrote: > On Sat, 2003-06-07 at 10:16, Anne Wilson wrote: > > Sounds like a conflict to me. I think you have installed two > > drivers - one from the Agfa disk and one from the Mandrake > > install. If it were me, I would try getting rid of the stuff > > from the Agfa disk, then go back to Hardware List and run the > > config tool again. See if XSane runs it then. > > > > Anne > > > > > > _________________________________________________________________ > >_____ > > OK, i put a comment sign in snapscan.conf where the firmware is > indicated. Next I rebooted because hardware detection went very > very slow. After reboot I configured my scanner again and fired up > Xsane. Now I got the error: > > Failed to open device:"snapscan:/dev/usb/scanner0': Invalid > argument. > > Still no cigar. > > Marco
Well, at least it's easy to reverse <g> It still sounds like a conflict to me, but I have no more suggestions. Sorry Anne
Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com
