signal 11 is probably a protection signal from the processor.
or in English
the installer is running in 'protected' mode, this means it can protect your
computers resources from bugs, malicious , or badly written programs
causing to much damage,
when a program tries to access something it shouldn't, a signal is generated
to the installer (11 in your case)
I'm sure someone who can remember what signal 11 is can give you a better
description of your problem,
or you can look it up on the web, try searching for DPMI documentation, or
looking at Intel's manuals on there web site.
basically a bit of the installer has a bug in it(though I'm not sure what).
if it's as soon as the installer loads it may be having problems with your
cd-rom drive or bios,
make sure the pnpos option is off in the bios. (any other suggestions?).
if it's further through the installation process try not installing things
through the installer, you can always install them later.
> -----Original Message-----
> From: Huelskamp, VT [mailto:[EMAIL PROTECTED]]
> Sent: 11 April 2000 12:08
> To: '[EMAIL PROTECTED]@inter2'
> Subject: RE: [newbie] Installation Problem
> Sensitivity: Personal
>
>
> I take it that no one has any idea??
>
> -----Original Message-----
> From: Huelskamp, VT
> Sent: Monday, April 10, 2000 3:27 PM
> To: '[EMAIL PROTECTED]@inter2'
> Subject: [newbie] Installation Problem
> Sensitivity: Personal
>
>
> While installing 7.0 on a Dell Dimension, 400mhz Celeron,
> after you select the packages, the install program shuts down
> with an error " Exited Abnormally, Received Signal 11" ??
> What is going on? Version 6.0 installed with little problems.
>
> TIA
>
> VT Huelskamp
>
