Could also be the PC-Chips Virus software or simular type of virus
software, that has to be DISABLED as well as the PNP when loading Linux.

don
                    I thought I knew that I knew what I thought
                    But now I know that what I thought I knew
                    Isn't what I know I think I thought I knew.


On Tue, 11 Apr 2000 12:23:27 +0100 Oliver Stieber <[EMAIL PROTECTED]>
writes:
> signal 11 is probably a protection signal from the processor.
> or in English
> the installer is running in 'protected' mode, this means it can 
> protect your
> computers resources from bugs,  malicious , or badly written 
> programs
> causing to much damage,
> when a program tries to access something it shouldn't, a signal is 
> generated
> to the installer (11 in your case) 
> I'm sure someone who can remember what signal 11 is can give you a 
> better
> description of your problem,
> or you can look it up on the web, try searching for DPMI 
> documentation, or
> looking at Intel's manuals on there web site.
> 
> basically a bit of the installer has a bug in it(though I'm not sure 
> what).
> if it's as soon as the installer loads it may be having problems 
> with your
> cd-rom drive or bios,
> make sure the pnpos option is off in the bios. (any other 
> suggestions?).
> 
> if it's further through the installation process try not installing 
> things
> through the installer, you can always install them later.
> 
> 
> 
> 
> > -----Original Message-----
> > From: Huelskamp, VT [mailto:[EMAIL PROTECTED]]
> > Sent: 11 April 2000 12:08
> > To: '[EMAIL PROTECTED]@inter2'
> > Subject: RE: [newbie] Installation Problem
> > Sensitivity: Personal
> > 
> > 
> > I take it that no one has any idea??
> > 
> > -----Original Message-----
> > From: Huelskamp, VT 
> > Sent: Monday, April 10, 2000 3:27 PM
> > To: '[EMAIL PROTECTED]@inter2'
> > Subject: [newbie] Installation Problem
> > Sensitivity: Personal
> > 
> > 
> > While installing 7.0 on a Dell Dimension, 400mhz Celeron, 
> > after you select the packages, the install program shuts down 
> > with an error " Exited Abnormally, Received Signal 11"  ??
> > What is going on?  Version 6.0 installed with little problems.  
> > 
> > TIA
> > 
> > VT Huelskamp
> > 
> 

________________________________________________________________
YOU'RE PAYING TOO MUCH FOR THE INTERNET!
Juno now offers FREE Internet Access!
Try it today - there's no risk!  For your FREE software, visit:
http://dl.www.juno.com/get/tagj.

Reply via email to