Need Help. I'm running a HP Vectra XU with (1) 2GB ST3255ON ; (4) 18GB ST318416N SCSI drives and a Sony SCSI CDROM. The (4) 18GB disks are in an external HP1350SE tower. The SCSI controller is on the system board and is an Adaptec AIC-7880 Ultra SCSI. All the drives are narrow channel. When I load MD7.1 with only the 2GB drive everything works on boot-up. When I load MD7.1 with all (5) SCSI drives the install completes without a problem. When I boot using Linux on Grup I get the following errros: Boot Done. Enabling symmetric IO mode.......done. Enabling IO-APIC IRQs ... changing IO-APIC physical APIC ID to 16 Kernal panic : could not set ID ... In swapper task - not syncing (the system hangs) When I boot using Linux-Up on Grup the system boots, however as the processes are started my eth0 will not start. I get: Bringing up interface eth0 - Delaying eth0 initialization..................[failed] The system is fine all the devices are mounted and accessible - but I can't get to my network? I need help?
