I would avoid using Grub and go to Lilo until this was figured out. Sorry if I have not been very helpful, but I at least like to try so you not think your ignored :) On Tue, 29 Aug 2000, you wrote: > Need Help. > > I'm running a HP Vectra XU with (1) 2GB ST3255ON ; (4) 18GB ST318416N SCSI > drives and a Sony SCSI CDROM. The (4) 18GB disks are in an external > HP1350SE tower. The SCSI controller is on the system board and is an > Adaptec AIC-7880 Ultra SCSI. All the drives are narrow channel. > > When I load MD7.1 with only the 2GB drive everything works on boot-up. When > I load MD7.1 with all (5) SCSI drives the install completes without a > problem. When I boot using Linux on Grup I get the following errros: > > Boot Done. > Enabling symmetric IO mode.......done. > Enabling IO-APIC IRQs > ... changing IO-APIC physical APIC ID to 16 > KKernal panic : could not set ID > ... In swapper task - not syncing > ((the system hangs) > > When I boot using Linux-Up on Grup the system boots, however as the > processes are started my eth0 will not start. I get: > > Bringing up interface eth0 - Delaying eth0 > initialization..................[failed] > > The system is fine all the devices are mounted and accessible - but I can't > get to my network? > > I need help?
