I'm trying to compile the CVS... I think I'm missing some steps
because all the drivers are giving unresolved symbols...
I've been restling with this on and off now for over a week... so will
someone please just look at the steps I take below and tell me what I'm
missing?
1) I read the docs again...
2) I make a directory and lndir the xc directory into it...
(same problem accours even if I don't do this)
3) I edit the the site.def and uncomment the HasGcc2...
(same problem accours even if I don't do this)
4) I then run make World >& world.log and tail -f the world.log
5) I finnally make install >& install.log and tail -f the install.log
Both the make World and make install go through without a single
hitch...
At this point I'll attempt to run either xf86config or XFree86
-configure
and I'll recieve the unresolved symbols.
(Yes I've removed the previous /etc/X!! and /usr/X11R6 directories...)
So what am I missing? Can you think of anything?
_______________________________________________
Newbie mailing list
[EMAIL PROTECTED]
*** To unsubscribe , or change message options, see:
http://XFree86.Org/mailman/listinfo/newbie
