This is exactly what I have in my config file as well. Are you running 4.1.0? I am surprised that it is working for you and not for me. Did you specify any additional parameters in your r128 device section?
John > -----Original Message----- > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On > Behalf Of Steve Brandli > Sent: Friday, January 18, 2002 1:14 PM > To: [EMAIL PROTECTED] > Subject: RE: [Newbie]ATI Xpert 128 w/Mandrake 8.0 > > > It's a little bit of a pain for me to move the file over. > But here's what > I did. I changed the name and the board to add the "PP" on > the end, I > added the ChipID to 0x5046, and I also changed the screen > section to refer > to the PP as well (since I changed the name in the device > section). That's > it! If this isn't clear, I'll go the extra mile and send you > the text. > > Steve > > At 10:16 AM 1/18/2002 -0500, you wrote: > >Steve, > > > >Are you setting your ChipID to 0x5046 or something else > (maybe you could > >share your r128 device section)? I would like to get > acceleration working > >on my Xpert 128 PCI. > > > >John > > > > > >_______________________________________________ > >Newbie mailing list > >[EMAIL PROTECTED] > >*** To unsubscribe , or change message options, see: > >http://XFree86.Org/mailman/listinfo/newbie > > _______________________________________________ > Newbie mailing list > [EMAIL PROTECTED] > *** To unsubscribe , or change message options, see: > http://XFree86.Org/mailman/listinfo/newbie > _______________________________________________ Newbie mailing list [EMAIL PROTECTED] *** To unsubscribe , or change message options, see: http://XFree86.Org/mailman/listinfo/newbie
