For starters, if you haven't allready done this: you might verify that the throttle stop plate is contacting the screw end and verify when you turn the screw the throttle plate rotates with it. If that is all correct - then let someone with more carb knowledge than I respond.
Are the carbs resonably synched - I could see where this could raise the minimum idle above normal if the carbs 1,3,and 4 were (or a subset) were sufficient open more than carb 2. Paul On Aug 22, 4:55 pm, "Creative Residential Designs" <[email protected]> wrote: > Hey gang...I got my Nightmare Nighthawk together and running. Unfortunately, > once it warms up it idles too fast. I turn the screw tight up to the engine > (left if you were to be looking straight at it) and it stays the same. I turn > it right and nothing as well. It's the little things that get me and after 4 > weeks of straight wrenching to get one ride running I'm just tired. Any > ideas? The screw is hard to get to on this one. Shall I wait for it to get > cold and then see if I can remove the screw and see if it has problems? > BROTHER! HotrodMamma. --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "Nighthawk Motorcycle Lovers!" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/nighthawk_lovers?hl=en -~----------~----~----~----~------~----~------~--~---
