Go over the cable routing to start with and make sure you have free-play on 
both. Next, as long as the throttle stop adjustment really does work properly, 
the individual carb stops are set too high. Disconnect the cables and start the 
motor. Can you turn it down ? Y-N ? If no, it's the carb sync screws. If yes, 
it's the cable adjustments. Some tuners (?) will make up for a poorly running 
motor by turning up the screws to get it to idle. The world is full of hacks. 

--- On Sat, 8/22/09, Creative Residential Designs <[email protected]> 
wrote:

From: Creative Residential Designs <[email protected]>
Subject: [Nighthawk Lovers] Throttle stop screw....
To: [email protected]
Date: Saturday, August 22, 2009, 7:55 PM



 
 

Hey gang...I got my Nightmare Nighthawk together 
and running. Unfortunately, once it warms up it idles too fast. I turn the 
screw 
tight up to the engine (left if you were to be looking straight at it) and it 
stays the same. I turn it right and nothing as well. It's the little things 
that 
get me and after 4 weeks of straight wrenching to get one ride running I'm just 
tired. Any ideas? The screw is hard to get to on this one. Shall I wait for it 
to get cold and then see if I can remove the screw and see if it has problems? 
BROTHER! HotrodMamma.







      
--~--~---------~--~----~------------~-------~--~----~
You received this message because you are subscribed to the Google Groups 
"Nighthawk Motorcycle Lovers!" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to 
[email protected]
For more options, visit this group at 
http://groups.google.com/group/nighthawk_lovers?hl=en
-~----------~----~----~----~------~----~------~--~---

Reply via email to