Let me see if I can dig up a wiring diagram. Sent via BlackBerry by AT&T
-----Original Message----- From: Graham Rogers <[email protected]> Sender: [email protected] Date: Sat, 25 Aug 2012 15:51:11 To: <[email protected]> Reply-To: [email protected] Subject: Re: [Nighthawk Lovers] Turn signal problems - AGAIN ALLEN! all bulbs are good, I just changed the whole left handle bar controls which includes all the wires to the turn signals and the fuse block harness - no change. On Aug 25, 2012, at 3:01 PM, Allen Thomas wrote: > Oops sorry, Kurt's is sound, I'd also add to try a known good set of bulbs. > Sent via BlackBerry by AT&T > From: Graham Rogers <[email protected]> > Sender: [email protected] > Date: Sat, 25 Aug 2012 14:48:32 -0400 > To: <[email protected]> > ReplyTo: [email protected] > Subject: Re: [Nighthawk Lovers] Turn signal problems - AGAIN ALLEN! > > thanks Kurt > > On Aug 25, 2012, at 2:46 PM, Kurt Nolte wrote: > >> Hum. Not sure then. It must be wiring related, and to take out all four it >> must be in the common preswitch wiring. Assuming your fuses are good, I >> suspect a break but not a short; continuity check the wiring from fuse to >> relay and from relay to switch. >> >> Kurt >> >> On Aug 25, 2012 2:38 PM, "Graham Rogers" <[email protected]> wrote: >> No, I switch relays >> >> On Aug 25, 2012, at 2:33 PM, Kurt Nolte wrote: >> >>> Bad turn signal relay, perhaps? The signal relay provides power to the >>> switch intermittently, so a bad relay could make for no turn signals. >>> >>> Kurt >>> >>> On Aug 25, 2012 2:20 PM, "Graham Rogers" <[email protected]> wrote: >>> This summer I bought a 1983 Nighthawk 650 at a yard sale. It had been in a >>> barn for many years and was home to a family of mice or whatever lives in >>> PA barns. Someone had remove the boots between the carbs and the air box >>> which delighted the mice no end because it provided them with four aluminum >>> waste disposal units. Some of the wiring was eaten through. I have >>> replaced what I could, replaced the waste disposal units and cleaned, >>> cleaned and cleaned. I have the motor running, it runs real nice and >>> everything works except the TURN SIGNALS. >>> Here's what I've got. The front signals running lights work. When I >>> activate the left hand signal, the left hand running light goes off but the >>> turn signal element does not work. Activating the right hand turn signal >>> does the same. The RH running light goes out but the turn signal element >>> doesn't work The rear turn signals do not come on at all. So, Allen, >>> Jason, anybody, WHAT'S GOING ON? Graham >>> >>> -- >>> You received this message because you are subscribed to the Google Groups >>> "Nighthawk Motorcycle Lovers!" group. >>> To post to this group, send email to [email protected]. >>> To unsubscribe from this group, send email to >>> [email protected]. >>> For more options, visit this group at >>> http://groups.google.com/group/nighthawk_lovers?hl=en. >>> >>> >>> -- >>> You received this message because you are subscribed to the Google Groups >>> "Nighthawk Motorcycle Lovers!" group. >>> To post to this group, send email to [email protected]. >>> To unsubscribe from this group, send email to >>> [email protected]. >>> For more options, visit this group at >>> http://groups.google.com/group/nighthawk_lovers?hl=en. >> >> >> -- >> You received this message because you are subscribed to the Google Groups >> "Nighthawk Motorcycle Lovers!" group. >> To post to this group, send email to [email protected]. >> To unsubscribe from this group, send email to >> [email protected]. >> For more options, visit this group at >> http://groups.google.com/group/nighthawk_lovers?hl=en. >> >> -- >> You received this message because you are subscribed to the Google Groups >> "Nighthawk Motorcycle Lovers!" group. >> To post to this group, send email to [email protected]. >> To unsubscribe from this group, send email to >> [email protected]. >> For more options, visit this group at >> http://groups.google.com/group/nighthawk_lovers?hl=en. > > > -- > You received this message because you are subscribed to the Google Groups > "Nighthawk Motorcycle Lovers!" group. > To post to this group, send email to [email protected]. > To unsubscribe from this group, send email to > [email protected]. > For more options, visit this group at > http://groups.google.com/group/nighthawk_lovers?hl=en. > > -- > You received this message because you are subscribed to the Google Groups > "Nighthawk Motorcycle Lovers!" group. > To post to this group, send email to [email protected]. > To unsubscribe from this group, send email to > [email protected]. > For more options, visit this group at > http://groups.google.com/group/nighthawk_lovers?hl=en. -- You received this message because you are subscribed to the Google Groups "Nighthawk Motorcycle Lovers!" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/nighthawk_lovers?hl=en. -- You received this message because you are subscribed to the Google Groups "Nighthawk Motorcycle Lovers!" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/nighthawk_lovers?hl=en.
