My understanding was that the tap method was to jar loose a stuck solenoid
not the actual starter. That makes a lot more sense to me personally.
            -Joey


On Mon, Aug 19, 2013 at 2:09 PM, Kyle Munz <[email protected]> wrote:

> BANG GENTLY! More like tap,and with a rubber mallet rather than a hammer.
> The starters on these bikes are made of thinner stuff than a car starter.
> Honestly, in theory the tap it with a hammer while trying to start sounds
> good, and when on the side of a dark highway with no alternatives I've
> certainly tried it, but I've had very limited success with that method. I
> would recommend just cracking it open at this point.
>
>
>
> -Kyle
>
>
> On Mon, Aug 19, 2013 at 12:56 PM, Jason King <[email protected]> wrote:
>
>> Try the test again and bang the starter with a hammer while you are
>> trying to start it and see if it works.
>> On Aug 19, 2013 1:37 PM, "Javier Garcia" <[email protected]> wrote:
>>
>>> Although i agree with the comments about the battery, i suggest
>>> repairing the starter anyway. Is a simple procedure, and you have it off
>>> the bike already. That way you will have piece of mind, specially after all
>>> the work you have already put on this bike.
>>>
>>> Javier
>>> On Aug 19, 2013 1:32 PM, "Joey Kelley" <[email protected]> wrote:
>>>
>>>> Battery chargers - particularly the automatic kind that tell you when
>>>> it is charged - have been known to be incorrect in the event of a battery
>>>> that is suffering a failure.
>>>>           If you ran the starter motor off another battery - like from
>>>> your car for instance and it turns - the issue is most likely the battery
>>>> or something downstream from it in the wiring. If you connect it to a
>>>> different power source entirely and it doesn't turn over - I would suspect
>>>> the starter.
>>>>            -Joey
>>>>
>>>>
>>>> On Mon, Aug 19, 2013 at 1:19 PM, Jeff <[email protected]> wrote:
>>>>
>>>>> Allow me to clear it up.
>>>>> I removed the starter motor from the engine and the battery as well.
>>>>> I used a jumper cable to connect the starter motor to the battery
>>>>> The starter motor ran for 1/2 a sec and never again.
>>>>> The engine as far as I can tell was moving before I installed it.
>>>>> I used a battery charger to recharge the battery until the device said
>>>>> it's fully charged
>>>>>
>>>>> --
>>>>> You received this message because you are subscribed to the Google
>>>>> Groups "Nighthawk Motorcycle Lovers!" group.
>>>>> To unsubscribe from this group and stop receiving emails from it, send
>>>>> an email to [email protected].
>>>>> To post to this group, send email to [email protected]
>>>>> .
>>>>> Visit this group at http://groups.google.com/group/nighthawk_lovers.
>>>>> For more options, visit https://groups.google.com/groups/opt_out.
>>>>>
>>>>
>>>>
>>>>
>>>> --
>>>> -Joey Kelley
>>>> JoeyKelley.com - My Life Online
>>>> JoeyFixesComputers.com - Its What I Do!
>>>> JoeyKelleyPhoto.com - Photographing Today, For Tomorrow
>>>>
>>>> --
>>>> You received this message because you are subscribed to the Google
>>>> Groups "Nighthawk Motorcycle Lovers!" group.
>>>> To unsubscribe from this group and stop receiving emails from it, send
>>>> an email to [email protected].
>>>> To post to this group, send email to [email protected].
>>>> Visit this group at http://groups.google.com/group/nighthawk_lovers.
>>>> For more options, visit https://groups.google.com/groups/opt_out.
>>>>
>>>  --
>>> You received this message because you are subscribed to the Google
>>> Groups "Nighthawk Motorcycle Lovers!" group.
>>> To unsubscribe from this group and stop receiving emails from it, send
>>> an email to [email protected].
>>> To post to this group, send email to [email protected].
>>> Visit this group at http://groups.google.com/group/nighthawk_lovers.
>>> For more options, visit https://groups.google.com/groups/opt_out.
>>>
>>  --
>> You received this message because you are subscribed to the Google Groups
>> "Nighthawk Motorcycle Lovers!" group.
>> To unsubscribe from this group and stop receiving emails from it, send an
>> email to [email protected].
>> To post to this group, send email to [email protected].
>> Visit this group at http://groups.google.com/group/nighthawk_lovers.
>> For more options, visit https://groups.google.com/groups/opt_out.
>>
>
>  --
> You received this message because you are subscribed to the Google Groups
> "Nighthawk Motorcycle Lovers!" group.
> To unsubscribe from this group and stop receiving emails from it, send an
> email to [email protected].
> To post to this group, send email to [email protected].
> Visit this group at http://groups.google.com/group/nighthawk_lovers.
> For more options, visit https://groups.google.com/groups/opt_out.
>



-- 
-Joey Kelley
JoeyKelley.com - My Life Online
JoeyFixesComputers.com - Its What I Do!
JoeyKelleyPhoto.com - Photographing Today, For Tomorrow

-- 
You received this message because you are subscribed to the Google Groups 
"Nighthawk Motorcycle Lovers!" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
To post to this group, send email to [email protected].
Visit this group at http://groups.google.com/group/nighthawk_lovers.
For more options, visit https://groups.google.com/groups/opt_out.

Reply via email to